Hello UStik,

About the Taurus, you are right, and I am glad too. But I have to do a second check with the laser.
(Yes gents in the future also this Taurus has components made with the using of the “laser”!)

And the copy crate picture in the future!

B.T.W. All I do depends on very little details I found on the crate picture.

For example I can see both dowels of the fuse in the crate, that gives me the possibility to make “3D” checks. These little details makes it possible to do the job!!!!!
Interesting for you UStik see post 231 page 10 Ed Kazmirski’s Taurus, picture 1, your hatch, and the tape, also on this Taurus!

Also your backup measurement is proved!! Congrats UStik.

About the Emco Unimat, picture 2, as an example, the pneumatic retracts of the Orion. Could not make it without the Emco.
I do have the Emco from about 1968, I was 17 year. My father bought it for me!
Also to make venturies for the vario for gliders (3,4) and pitot tubes (5) for speed measurements, and so on. For me no life without my Emco.

Cees