RCU Forums - View Single Post - Are there any kits of 3D planes?
View Single Post
Old 10-11-2008 | 11:52 AM
  #16  
Gray Beard
My Feedback: (-1)
 
Joined: Apr 2003
Posts: 14,400
Received 9 Likes on 8 Posts
From: Hemderson, NV
Default RE: Are there any kits of 3D planes?

Kinda sorta but nota. We had built A new house and this was our old mobil home that my wife had me keep for my shop. I had the two back bedrooms for my hanger. the den with french doors held all my power tools, the living room was my building room, between the living room and kitchen I had pullys for ballancing and CG hung from A beam, the kitchen area was used for the times I needed A CG machine, and the area where the washer and dryer were was my spray booth. My shop had all the good stuff in it too, cooling for summer, gas heat and A wood burning air tight for winter, bath room and A fridge full of beer. Shop lights over my building board and A sound system that may have been old but you could really feel the music. Yes, I miss that shop, my new one is very small but better then A lot I have seen. I'm A very lucky boy!!!