Don't have too much time so let me write this fast. . .

Flew with a 4s setup because my 5s batteries didn't show up in the mail yet . . . 4s on a 17x10 and an A50-12s and the graph is below.

Empty Weight (no battery) 4 lbs 12 ozs
Angel + 4s 3300mAh TP 5 lbs 8 ozs

Had the same problem regarding elevator trim as shown one or two pages back. Checked the incidence and found stab is more than 1 degree nose down different from wing.

I hate building so I always have complaints about the build, and for me I will never again buy an ARF with a pull-pull. Otherwise the quality and the flying characteristics were outstanding.


What is the concensus on incidence problems? I hate building so repair of the incidence is out of the question. Should I buy another model and hope for better, or is there something else to be done?


Thanks,


Joe