I have been setting the Switches, Knobs, and Sticks, such that the Servos will move to these PreSet positions upon a FailSafe event. Then I BIND the Rx to the Tx.

I was told, by a JR rep, at a Jet meet I went to this summer, that there was another procedure I had to follow to get the servos on All the channels to go to the desired PreSet positions during a FailSafe event.

In the case of the 9303 and the AR9000, is it possible to set All the channels to a PreSet position upon FailSafe, and if so, does the system go briefly into FailSafe, upon boot up?

Sorry to be so Lame Brained!!!