Hey everyone, I bought an HPI Nitro MT 1 on the day it came out (a long time ago). I used it often and took very good care of it. Well, it has been a couple years since it has gotten any attention. I cleaned it up, and ordered a new engine for it (the HPI G3.0). I have a few questions....

1. What maintenance would you recommend since it has been sitting on a shelf so long?

2. With this new engine, do I need to get a new flywheel, clutch shoes, springs, clutch bell, etc?

3. Which fuel tank should I get? Can I use the MT2's 100cc tank as a direct replacement with my MT1 tank?

4. Which engine mount should I get?

5. Which air filter should I get?

Sorry for all of the questions. There is a lot of information to dig through in this thread, and I have been away from nitro RC for a long time. Thanks for all of your help.

-TC