RCU Forums - View Single Post - Official HPI MT2 Thread
View Single Post
Old 01-31-2009 | 03:42 PM
  #18805  
MattVid
Senior Member
My Feedback: (1)
 
Joined: Jan 2009
Posts: 121
Likes: 0
Received 0 Likes on 0 Posts
From: Bothell, WA
Default RE: Official HPI MT2 Thread

New car is looking good Keith.

Update on my car. Finished sealing and rebuilding the engine with the new gaskets. It warmed up a little today, even though there is still snow outside, I fired up the car and it RUNS! It's aliiiive! I am pretty stoked, just hope it warms up and dries out some so I can tune it up. Let it run a full tank in idle/low/medium speed and it seems pretty smooth. It is running very rich at the moment, but I just wanted to get the engine a little lubed up and make sure it worked.

I will post some pictures up a little later, but just wanted to let everyone know, I am up and running ... and my first engine rebuild was a success