RCU Forums - View Single Post - Another Idle Screw Question.
Thread: Another Idle Screw Question.
View Single Post
Old 02-01-2009 | 02:32 PM
  #3  
DaveG55's Avatar
DaveG55
Senior Member
 
Joined: Jan 2005
Posts: 8,275
Likes: 0
Received 2 Likes on 2 Posts
From: Stockbridge, GA
Default RE: Another Idle Screw Question.
It looks like you have a rotary carb. You need to adjust "this opening" not the one near the HSN.

If it were a slide carb then you would be adjusting the opening near the HSN but you would not have any opening at "this opening".
DaveG55 is offline  
Reply Like