RCU Forums - View Single Post - correcting uneven stab?
Thread: correcting uneven stab?
View Single Post
Old 02-01-2009 | 05:41 PM
  #2  
jetmech05
 
Joined: Jul 2005
Posts: 4,865
Likes: 0
Received 0 Likes on 0 Posts
From: Jacksonville, FL
Default RE: correcting uneven stab?
a picture is worth a thousand words....are you talking the stab is on fuselage and is off 1/4 inch? or the stab is laying on the table and one side is off a 1/4 in? is it a one piece stab or two connected by a rod?
jetmech05 is offline  
Reply Like