Well when time is on your side why not eh. Seem to have lots of it lately. Not sure this will work out but at least I will have tried and learned something if nothing else. I have never milled wood before and just thought what the heck...I'll look up properties of wood in my machinists handbook and found it! That book has it all. Learning a ton from it and it has not even been cut yet. Didn't know they broke wood down so far. This is interesting stuff for sure. I hope a 2 flute mill will work good. If nothing else it may serve as a good rougher. I need to order more tooling bad. Limited to about 10 endmills and a few face mills. Just getting set up with my mill and lathe. Never would have pictured wood chips on my mill though.

Kevin