RCU Forums - View Single Post - Gas Engine for 1/4 Scale Balsa USA J-3 Cub
Old 02-23-2009 | 07:36 PM
  #48  
Edwin
My Feedback: (2)
 
Joined: Feb 2002
Posts: 6,204
Likes: 0
Received 1 Like on 1 Post
From: Leander, TX
Default RE: Gas Engine for 1/4 Scale Balsa USA J-3 Cub

Thanks Bass1.

Sometimes I ramble. If one of my buddies talks rc at a party, my wife has to grab me and drag me away when its time to leave.

Your Eclipse 7 should do it. Thats what I used for about 5 years on all my planes. Still have it. For a cub, you'll be using the primary 4 channels. Which leaves 3 channels for options. You can set your gear switch to control your ignition on/off. There is knobs for I dont know what ever you want. Point is, the Eclipse 7 will do the job. I use unbuffered Y servo cables for my ailerons on planes like cubs and other slow general avaition.
Hanna Montana? Oh puhleeze! Thats blasphemy. Vailly Aviation has some decent full body pilot figures in 1/4 scale. I have one going in my busa J3 and L4, (1/4 ww2 FF shown in picture).
http://vaillyaviation.com/Intro.html
Edwin