RCU Forums - View Single Post - Ryobi conversion running poorly
Thread: Ryobi conversion running poorly
View Single Post
Old 03-24-2009 | 10:12 PM
  #15  
Racinrc14
My Feedback: (7)
 
Joined: Jun 2003
Posts: 141
Likes: 0
Received 0 Likes on 0 Posts
From: Springfield, IL,
Default RE: Ryobi conversion running poorly
The low side needle is bit longer in reach than the high side. It even states that in the Zama information above. No information on the governor assembly, though.
Racinrc14 is offline  
Reply Like