RE: Ed Kazmurski's Taurus
Ustik, the instructions call it Max-40 R/C, I believe the H40P was the racing (P=pylon) engine. I am already running one of these old 40 R/C's in a 362 delta where it works very well and this one was to be my 'spares' engine (You can't get the bits any more, you know). I still don't know which to use, but as the bearer spacing is very similar I can continue cutting bits and decide later. The same mounting hole spacing would be too much of a coincidence to expect, so it might end up with the engine I can find spares for.
Evan.