RCU Forums - View Single Post - Using a "TopFlite" Prop Balancer
Thread: Using a "TopFlite" Prop Balancer
View Single Post
Old 04-19-2009 | 11:31 PM
  #8  
redfox435cat's Avatar
redfox435cat
Senior Member
 
Joined: Mar 2005
Posts: 1,469
Likes: 0
Received 0 Likes on 0 Posts
From: Lompoc , CA
Default RE: Using a "TopFlite" Prop Balancer
I very carefully sawed the tips about an 1/8th inch off each cone and have never had a problem with them touching since. put the shaft in an electric drill and lightly sand with 300 grit paper to true out the cones
redfox435cat is offline  
Reply Like