RCU Forums - View Single Post - Problems with hovering
View Single Post
Old 05-08-2009 | 09:04 AM
  #17  
FKY1000
Senior Member
 
Joined: Feb 2004
Posts: 128
Likes: 0
Received 0 Likes on 0 Posts
From: San Francisco, CA
Default RE: Problems with hovering

well, if ur eng is leaning at midrange and not full, ull need a temperature gate to tune it right, but then try to richen the low end as much as posible as long as u have good idle and decent throttle response for pulling out of the hover.

make sure ur glow plug is good and the fuel too before u richen it out, other wise it will not hold idle for longer than 15 +0- secs.