I just replaced the 8411's in the elevators of my Kingcat with 2 brand new 8611's. The 8411's were perfect, they didn't glitch around, bounce, nothing, but I put a bigger engine on, so wanted stronger servo's. Well, the new 8611's are giving me problems.
The setup is, JR 12X 2.4 radio w/AR9000 receiver. Duralite power box running 2 7.4V lipo's. 2 new 8611's running through the power box.
At neutral both servo's are dead solid, when they are at full deflection they are solid, but through the travel both up and down, particularly the right servo's is bouncing on me about 1/2". If I put some pressure on the surface while moving it, it doesn't bounce.

These are both 2 new fresh out of the pack servo's. Any idea's from anyone?
Jeremy