RCU Forums - View Single Post - What amount of coupling to use between elevator and flaps.
Thread: What amount of coupling to use between elevator and flaps.
View Single Post
Old 06-22-2003 | 04:19 PM
  #19  
outssider
Senior Member
My Feedback: (23)
 
Joined: Jan 2002
Posts: 1,192
Likes: 0
Received 1 Like on 1 Post
From:
Default What amount of coupling to use between elevator and flaps.
Graeme....


I can't get any flat spins either with the mix on.....must be off.

the phenomenon with needing more elevator throw for upright flat spin is also very noticeable in my 540 edge. upright requires full 3d rate while inverted can be done on lower rates (for elevator).
outssider is offline  
Reply Like