RCU Forums - View Single Post - thread information on OS 91 surpass
Thread: thread information on OS 91 surpass
View Single Post
Old 06-02-2009 | 05:14 PM
  #5  
JrBluz2
Junior Member
 
Joined: May 2009
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
From: Brandon, FL
Default RE: thread information on OS 91 surpass
Hello,
I was wondering if anyone could tell me the correct way that the rear bearing goes into the OS 91FS Surpass? A friend took mine out and didn't make note as to the direction it went. There is a metal side that is enclosed. The other side you can see bearings. Does the closed side face the rear or front of the motor? Please email me at [email protected] cause I am not sure if I can find my way back here. LOL
JrBluz2 is offline  
Reply Like