Wow, you've moved along very well, I'm right behind you, I got a chance to work on it last night.I managed to get the chine sheeting finished and blended to the sides and bottom, also got the front upper formers and stringers installed. Tonight I'm going to work on the back half and the cowls/ wheel pants. I figure while the tail pieces setup and cure I'll get the plastic parts done along with tinting the canopy. But we'll see how long I have to be at work for, absorbtion chillers are finiky you know, kinda like thinking outside the box of what's going on inside the box that you can see but only read tempatures and salt concentrations. If I got into it at any depth, it would take me about a week to get the concept and operation down solid with many people. But back to work and I'll post some pic's of my progress as well. Funny though, I'm still bouncing back and forth with the covering bit, koverall and dope or monocote, can't decide wich to do at this point but I need to figure that point out, also thinking of going pull pull on the rudder and using two seperate pushrods for the elevators, we'll see.