When setting up my CG per the instructions, I have the assembled plane with no fuel, balanced on two dowels.
I can move the plane forward and back quite a bit and still be "balancing" on the dowels.
When I say "balance" Imean it doesnt fall off the dowels! The nose can be high or low but still "balance" on the dowels.

Would I be correct to use a small bubble level on the tail surface to balance the plane with the tail surface level?

Icant leave the bubble there to balance because of the weight but Iused it to get the tail close to level while the plane is on the dowels...

Ibelieve the CG is best determined while flying. I think My Tiger 60 is nose heavy but I dont realy have the experience to be sure?

Its flying ok but I notice when I do a roll it wants to dive quite a bit during the roll.

Iknow I dont want to be tail heavy!


Steve