5955TG Failure
I just lost my 30% Aero-Works 260 due to a servo failure. The Rudder went to full deflection, while i was 3D'ing around. It caused me my airplane. I was using the Fromeco Sahara regulated to 6.1 so i dont think it was a voltage issue. Is this one possible way a servo dies? Ive had servo failures wher the servo is just dead and doesnt respond to power. This particualr 5955 is melted on the bottom, still responds to power , andstill goes to full deflection; however it doesnt respong to transmitter input
Has any one experienced this kind of servo death, or know of any one else.