12 FG QUESTION
Hi,
I'm trying to figure out why I cannot adjust my elevators end points seperatly....I have channel 7/8 assigned to the elevators, when I move the stick both servos work in the correct manner ( direction ) I can reverse them if needed. But when I try to adjust the end points on them I can only do it on one and those settings have no effect on the other. Now if I go to the "servo monitor" and move the stick just channel 7 shows movement. I can't figure out what I have done wrong? I have four seperate aileron servos on four different channels and I can adjust end points on all four them by themselves. How do I get to the point I can do so on my elevators??? Have channel 8 assigned to "eleavator2" and the control to J2 just like the other side of the elevator.
Thanks for any help