RCU Forums - View Single Post - Checkerboard iron on covering
Thread: Checkerboard iron on covering
View Single Post
Old 07-27-2009 | 09:17 AM
  #12  
Ed Smith
Senior Member
 
Joined: Dec 2001
Posts: 3,305
Likes: 0
Received 0 Likes on 0 Posts
From: Brantford, ON, CANADA
Default RE: Checkerboard iron on covering
Where did you get 6" checkers ? Or did you make them one at a time ?

I cut them out of Ultracoat. It does not take much time. I cut a six inch wide strip then just cut the strip up. I use one of those mats that have the lines on them.

Ed S
Ed Smith is offline  
Reply Like