I actually applied the fiberglass cloth on the bottom of the wing in addition to the top. Sorry I don't think there were pictures.

1) There were three layers of fiberglasss cloth applied to the center section. This time widths of 4", 10", and 14" were tacked on with 3M 77.

2) The aileron hinge (2 ounce glass or taffeta) was also tacked on with 3M 77.

3) Lightweight 3/4 ounce cloth was appled to both the top and bottom of the wing.

4) About 1.5 ounces of Skin It was applied on the bottom of the wing. It was spread with a squeegee.

5) About 1.25 ounces of Skin It was applied on the top of the wing. It was spread with a squeegee.

These were then placed in the peel ply and vacuum bag to dry.

The torque rods will be installed later.