RCU Forums - View Single Post - Drill guide for a DA-50 ?
Thread: Drill guide for a DA-50 ?
View Single Post
Old 09-19-2009 | 12:50 PM
  #8  
Ed
Senior Member
 
Joined: Dec 2001
Posts: 2,889
Likes: 0
Received 0 Likes on 0 Posts
From: Bemis, NM
Default RE: Drill guide for a DA-50 ?


" Without a drill press a drill guide is mandatory and still not always satisfactory."

I think that after reading this statement, the big question for me is, what is the best way to square up that table with the drill bit, and properly use a drill guide, so that it is perfectly accurate every time ? ? ?
Ed is offline  
Reply Like