RCU Forums - View Single Post - Question of ethics . . . needle valve tool
Thread: Question of ethics . . . needle valve tool
View Single Post
Old 09-24-2009 | 01:29 PM
  #4  
MinnFlyer's Avatar
MinnFlyer
Senior Member
My Feedback: (4)
 
Joined: Apr 2002
Posts: 28,519
Likes: 0
Received 9 Likes on 9 Posts
From: Willmar, MN
Default RE: Question of ethics . . . needle valve tool
I have ground the threads off a small hex head screw and put it into the needle valve's extension hole so that you can use a ball driver to turn it
MinnFlyer is offline  
Reply Like