BuschBarber

My Feedback: (2)

Thanks!! Normally, the handle on the DX7 would keep the button from being depressed if the Tx was laid on a flat surface. I was thinking of putting a Cap over the Bind Button and using Velcro to hold it on. I was also thinking of hooking a wire, with a loop on one end, to the Trainer Switch, and hanging it down the back of the Tx so I could pull it with one of my fingers so I could keep my Thumb on the Rudder/Throttle Stick when Training someone. The Trainer Switch is located in an awkward spot on the Dx7.

I have a Spektrum module for my XP9303. The Bind Button is much smaller and is closer to the back of the Tx. It is much more difficult to accidentally depress the Bind Button on that Tx.