RCU Forums - View Single Post - laminating sheet tail surfaces.
Thread: laminating sheet tail surfaces.
View Single Post
Old 10-17-2009 | 01:12 AM
  #23  
mikegordon10's Avatar
mikegordon10
 
Joined: Jul 2003
Posts: 988
Likes: 0
Received 0 Likes on 0 Posts
From: Provo, UT
Default RE: laminating sheet tail surfaces.
As near as I can determine every racer I've ever built is a new design. I don't think I've ever built two that were twins. There are similarity's to all of them but they are not totally the same. That would be way too easy.
mikegordon10 is offline  
Reply Like