basically the right side of the elevator points up and the left points down. it must have moved while drying but there wasnt any way I could clamp this area. As for looking like the rx was lost The plane was far out in front of me and when I went to make a right turn I barely started touching the stick,the plane went straight up and down and went into a dive, at this point it didnt feel like I had input. Somehow I managed to get out of it and as I was flying back towards me I tried going right again as soon as I touched the stick it did a very fast complete right roll. I started banking left and brought it past in front of me to get a look at it as soon as I wasnt holding the stick it was going hard right, I tried trimming but that didnt help much at all so I did a low circle all lefts and landed. I guess since I didnt have a problem taking off or through the first couple turns it seemed like I lost the rx. Before the repairs this plane flew like a dream and even though I havent been flying that long I know im better than what the plane was doing out there,its not like im unaware of whats going on or dont know how to fly well. I hope there is a way to fix this,I will try to get a pic.