I laminated three 1/8" ply motor mount plates with 6oz glass/epoxy between each layer and on the outsides. This made a nice 3/8"+ a bit thick and very solid beam mount. I'm tying it all together with some extra spar material and a couple of little mods here and there. I'm taking progress pics but too sleepy tonight for any more up/downloading plugging things in and out crap.. manana, manana. I think it will work, and there's room for everything too. The only big job is one more cowling plug and mold, but I'll try to make this a production prototype and therefore useable for any Demon. I didn't change the exterior envelope at all on this one for that reason.

The small block SE engine/tank cowl mold is curing overnight, then tomorrow morning I tear it apart, hopefully successfully. I get the first one, I get the first one, tra la la la laaa laa.. [sm=lol.gif]

MJD