RCU Forums - View Single Post - Robart hinge point question
Thread: Robart hinge point question
View Single Post
Old 11-11-2009 | 07:49 PM
  #7  
vertical grimmace's Avatar
vertical grimmace
My Feedback: (1)
 
Joined: Mar 2004
Posts: 7,269
Received 13 Likes on 12 Posts
From: Greeley, CO
Default RE: Robart hinge point question
I would go in new locations. Your drill bit will wander and I doubt you will get a good straight hole.
vertical grimmace is offline  
Reply Like