RCU Forums - View Single Post - How to, stiffen wire pushrods without adding too much weight.
Thread: How to, stiffen wire pushrods without adding too much weight.
View Single Post
Old 11-28-2009 | 07:21 PM
  #7  
Ernie P.
Senior Member
My Feedback: (3)
 
Joined: Sep 2007
Posts: 7,086
Likes: 0
Received 11 Likes on 11 Posts
From: Bealeton, VA
Default RE: How to, stiffen wire pushrods without adding too much weight.

ORIGINAL: Zippi

karolh,

Not sure how your setup is but if the 4-40 rod is all exposed I would buy some 4-40 all thread rod and some Mid West Carbon Fiber tubes and slide it over the 4-40 rods and lock it in place with 4-40 nuts on each end. Done this many times on big gassers.


That's a tip I'll remember. Thanks; Ernie P.
Ernie P. is offline  
Reply Like