RCU Forums - View Single Post - Getting engine back in service.
Thread: Getting engine back in service.
View Single Post
Old 11-28-2009 | 10:13 PM
  #20  
ro347
Senior Member
My Feedback: (13)
 
Joined: Jul 2005
Posts: 2,322
Likes: 0
Received 0 Likes on 0 Posts
From: Nutley, NJ
Default RE: Getting engine back in service.

ORIGINAL: ro347

Got it all cleaned up...now a little heat to dry up any moisture. Question: Only 1 part left if I can figure this out - How do I get the connecting rod pin out of the cylinder. I pulled out the little clips in the cylinder, but cant get the pin to slide out. Tried tapping it, nothin!!!! Any ideas?
I GOT IT - placed it in the oven at 200 for 20 minutes and it popped right out.

ro347 is offline  
Reply Like