RCU Forums - View Single Post - How to convert an ATX power supply to rc use
Thread
:
How to convert an ATX power supply to rc use
View Single Post
12-06-2009, 06:12 PM
#
189
Andrew
Join Date: Feb 2003
Location: Murray, KY
Posts: 3,214
Likes: 3
Received 3 Likes on
3 Posts
RE: How to convert an ATX power supply to rc use
Use a single 10 ohm 10 watt resistor. By adding two in series, your load is 20 ohms. You may see a slight increase in output voltage by dropping the resistance to 10 ohms.
andrew
Reply
Like
Andrew
View Public Profile
Send a private message to Andrew
Visit Andrew's homepage!
Find More Posts by Andrew
View iTrader Profile