RCU Forums - View Single Post - CGRCJets A-10 Build Thread
Thread
:
CGRCJets A-10 Build Thread
View Single Post
12-31-2009, 12:22 PM
#
277
cgrcjet
Join Date: Jul 2007
Location: paso robles, CA
Posts: 728
Likes: 0
Received 0 Likes on 0 Posts
RE: CGRCJets A-10 Build Thread
Installing the mains retracts
-I cut out a small notch for clearance of the air fitting.
-Mark forward about a 1/4" from the back side of the outline that was cut out for the retract. The back flange of the retract will butt up against this mark.
chris
Attached Thumbnails
Reply
Like
cgrcjet
View Public Profile
Send a private message to cgrcjet
Visit cgrcjet's homepage!
Find More Posts by cgrcjet
View iTrader Profile