RCU Forums - View Single Post - The Goldberg Ultimate biplane...is dead.
Old 01-01-2010, 01:43 PM
  #17  
Gray Beard
My Feedback: (-1)
 
Join Date: Apr 2003
Location: Hemderson, NV
Posts: 14,396
Likes: 0
Received 7 Likes on 7 Posts
Default RE: The Goldberg Ultimate biplane...is dead.

The kit was $200.00. For templates I just use any bond paper, my wood working club has it on a roll so I just pull what i need. If it's a plane that I think people will want a copy of then I will use Seetemp. Fromica sounds pretty good. I often go to Costco and pick up those big sheets of chip board, the 1/16 inch card board you find on the bottom of there pallets. Templates don't need to be fancy. I just made up a sheet for a little electric plane I'm building so if someone asks for a copy I can just have the sheet copied at the same time with the plans, very easy, I just trace the parts as I pull them. The smaller the sheet the cheaper the copy so I tend to crowd the parts. I have used my own printer for the instructions.