I'm very excited about a few new aquisitions.

I just scored a new ECHO SB1080 short block. That is the CS-530 chainsaw engine, it is the one that BME uses for their 50 classic. It rates 5-hp.

I also got an ECHO CS660EVL (64cc) to mess with. It will have to be freed from the case.

Finally a CS510EVL. I already did one of those but the crank is a little bent from a crash. It still runs good but it shakes more than it should. I straightened it to "very close, but now I have a straight crank to put in it.

What would be the prefered carb, with an accelerator, for the BME-50 clone project?