RCU Forums - View Single Post - KMP SBD Dauntless Build
Thread: KMP SBD Dauntless Build
View Single Post
Old 01-10-2010 | 05:01 PM
  #52  
efurche
Junior Member
 
Joined: Jul 2002
Posts: 27
Likes: 0
Received 0 Likes on 0 Posts
From: ft. worth, TX
Default RE: KMP SBD Dauntless Build
I am trimming the wheel well covers,and there are very brittle... Could I heat them in an oven just enought to soften them?

Did you have this problem? Ready to mount them ,,, sure would like a repy asap.

Thanks, Ed
efurche is offline  
Reply Like