RCU Forums - View Single Post - Cutting down a prop to a smaller size
Thread: Cutting down a prop to a smaller size
View Single Post
Old 01-15-2010 | 07:39 PM
  #1  
Richard39
My Feedback: (14)
 
Joined: Dec 2002
Posts: 996
Likes: 0
Received 1 Like on 1 Post
From: Birmingham, AL
Default Cutting down a prop to a smaller size
I have a couple of props that have been chipped and/or worn on the tip by contact with a hard surface that I would like to cut down about 1/4 inch... What concerns should I have in doing this... Not wood props... Thanks...
Richard39 is offline  
Reply Like