RCU Forums - View Single Post - Micro Mill
Thread: Micro Mill
View Single Post
Old 02-02-2010 | 10:31 PM
  #2  
captinjohn
 
Joined: Jan 2002
Posts: 12,957
Received 4 Likes on 4 Posts
From: Hesperia Michigan, MI
Default RE: Micro Mill
Here is a good starting point if you want to start using small lathes for doing engine conversions. Lots of good data! Capt,n http://www.rcuniverse.com/forum/m_49..._6/key_/tm.htm
captinjohn is offline  
Reply Like