RCU Forums - View Single Post - Needle Valve Initial Settings?
Thread: Needle Valve Initial Settings?
View Single Post
Old 02-03-2010 | 08:31 PM
  #1  
krashkart
Senior Member
My Feedback: (5)
 
Joined: Nov 2009
Posts: 453
Likes: 0
Received 0 Likes on 0 Posts
From: Up in the Mountains AZ
Default Needle Valve Initial Settings?
I picked up a couple of used trainers. I did not get any paperwork with either one.
One starts just fine, the other starts and then dies (I am priming the carb to get it started)
I may have a bad glow plug but the other thing I am not sure about is the initial needle valve settings.
It's a Tower Hobbies .46 Ball Bearing ABC motor.
Tower does have have a link to a manual on this motor (or I missed it).
Anyone?
krashkart is offline  
Reply Like