RCU Forums - View Single Post - Specs for an OS60?
View Single Post
Old 07-12-2003 | 03:28 AM
  #22  
AUSMPW
Member
 
Joined: Jul 2003
Posts: 42
Likes: 0
Received 0 Likes on 0 Posts
From: Wangaratta, AUSTRALIA
Default Specs for an OS60?

Jackin it up is outa the question as its a solid shaft drive and would require some major mods to realign it :-(

Certainly will add more castor but. And the only reason I ran it at fairly low speeds today was the fear factor :-) Usually it'll run flat out. I gave it a couple today but, well, nervs wins the day.

And Bob. Displacement? I don't understand? Later for the Fibreglass - where is the gaffa tape and cardboard

Marty