RCU Forums - View Single Post - Powerbox Sensor Switch setup
Thread: Powerbox Sensor Switch setup
View Single Post
Old 03-17-2010 | 06:06 AM
  #2  
steverobertsuk
Senior Member
 
Joined: Nov 2004
Posts: 161
Likes: 0
Received 0 Likes on 0 Posts
From: Maidenhead, , UNITED KINGDOM
Default RE: Powerbox Sensor Switch setup
I have not tried it on the Sensor switch from PowerBox but I have on the Gemini in my helicopters.

I just plugged a Y lead in so that I can charge with the batteries always connected to the switch as the installation was very tight. Its also a good way to check the remaining power with a battery checker.

Steve
steverobertsuk is offline  
Reply Like