RCU Forums - View Single Post - Reactor 60 bipe control horn question
Thread: Reactor 60 bipe control horn question
View Single Post
Old 03-30-2010 | 08:04 PM
  #1  
xinther
Junior Member
 
Joined: Oct 2008
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
From: Johnson City, FL
Default Reactor 60 bipe control horn question
Anybody ever have a failure on a control horn screwed into CA-hardened balsa?

I have a Reactor 60 Bipe ready to go, but am not confident that the control horns will hold on an aerobatic 3-D plane.

I prefer my surfaces to be captive by the horn, especially when the surfaces are so big.

I was looking for replacement horns that will conform to the taper, but can't find any. I am trying to avoid epoxying dowels and such.

Am I overreacting here?

Thanks for your time,
Carlos



xinther is offline  
Reply Like