RCU Forums - View Single Post - Lets Try To Mold A Moldie!
Thread
:
Lets Try To Mold A Moldie!
View Single Post
04-23-2010, 02:26 PM
#
16
D.E.
Senior Member
Join Date: Feb 2010
Location: Hemet, CA
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts
RE: Lets Try To Mold A Moldie!
Next,
#1 On this half the carbon in the nose goes from the wing saddel to just past the front of the motor mount tie in area.
#2 Both halves finished.
Next will be to trim fuse halves and join, that wii be tomorrow along with starting on some wing skins. Tonite I will get a horizontal into the vacuum bag.
Now to give the dog a bath to get the overspray off.
Dave E.
Attached Thumbnails
Reply
Like
D.E.
View Public Profile
Send a private message to D.E.
Find More Posts by D.E.
View iTrader Profile