RCU Forums - View Single Post - New CDI - opensource project JMJ and Bigboat
Thread: New CDI - opensource project JMJ and Bigboat
View Single Post
Old 05-15-2010 | 07:45 AM
  #1236  
Evert1969
Member
 
Joined: Sep 2006
Posts: 34
Likes: 0
Received 0 Likes on 0 Posts
From: Steenwijkerwold, NETHERLANDS
Default RE: New CDI - opensource project JMJ and Bigboat
During programming using the rcd programmer with Winpic i get the following error:

<font color="#ff0000">Resultaat van LoadHex: LastProgAdr=0x000242 LastDataAdr=0x0020FF (D:\Modelvliegen Evert\Saito benzine\CDI\CDI1.hex)
Programmeren...
Wissen ("bulk" of "Chip")
Wis chipgebruik algorithm "ERASE_16F62xA" .
Programmeren CODE, 0x000000..0x000242
Programmering 0x000000..0x000242, algo="16Fxx", CanRead=0 .
Vergelijk 0x000000..0x000242
Vergelijk foutr: 000006: lees 000045, benodigd 00008A
Vergelijk foutr: 000007: lees 003FFF, benodigd 000820
Vergelijk foutr: 000008: lees 003FFF, benodigd 000082
Vergelijk foutr: 000009: lees 003FFF, benodigd 000008
meerdere vergelijk fouten, onmogelijk deze alle te tonen (total=573)
Programmeren CONFIG, 0x002000..0x002007
Programmering 0x002000..0x002007, algo="CONFIG_MEM_16xxx", CanRead=0 .
Vergelijk 0x002000..0x002007
FOUT: Programmering Mislukt!

</font><font color="#000000">I'm using Winpic fot programming.  If i'm programming with the PIC directly on de RCDprogrammer i don't get the error but then  the CDI 'still isn't working.
Who can tell me wat's wrong?</font>
Evert1969 is offline  
Reply Like