Hi All

I have made up an Aurora 9 programing spreadsheet that I would like to share

It will allow you to put all your model settings into a printable spreadsheet................. yeah I hear ya why not just back it up to a model set with the HPP-22?

Well I will when my HPP-22 that is on order arrives, but I also like to see the settings and will still use it, so if you are interested there is three versions, all the same except for the amount of model pages pre-made. There is a 10, 20 & 30 model versions

If you get any of them, you can always make new pages by just copying a blank page

Hope you find it useful as I do and if you have any suggestions for changes, would be more than happy to look at.

First attachment below is 10 model, then 20 & 30

Mike, would it be ok to post this on the Hitec service page?