RCU Forums - View Single Post - GST 7.7 Brushless conversion help needed
Thread
:
GST 7.7 Brushless conversion help needed
View Single Post
08-22-2010 | 06:39 PM
#
12
merigold2005
Junior Member
Joined:
Dec 2006
Posts:
16
Likes: 0
Received 0 Likes on 0 Posts
From:
N.Attleboro, MA
RE: GST 7.7 Brushless conversion help needed
I didn't use the slider shaft because the end on it didn't match up with my center diff.I used dogbones from a Kyosho Inferno ST.They work well.You can also use 2 rear dogbones for the cen.
Reply
Like
merigold2005
View Public Profile
Send a private message to merigold2005
Find More Posts by merigold2005
View iTrader Profile
RE: GST 7.7 Brushless conversion help needed