G'day Downunder. I'm down there too. A question if I may. I have seen that you have a number of Enya engines. I picked up two Eny 40SS plain bearing engines on a certain auction site recently. One is fine and has been run in well and has a nice piston and liner fit. The second was described as "low use etc" but its piston and liner fit was useless so I bought a new P&L from Mr Enya. It is iron/steel and so will need some proper running in.

And now the question. How would you run-in an engine like this? (It is an RC engine if that makes a difference). I imagine lots of short rich runs?

Thanks.

Mike in Dubbo NSW