Blade CP Video Setup...
#1
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Portsmouth, NH,
Posts: 814
Likes: 0
Received 0 Likes
on
0 Posts
Blade CP Video Setup...
I am getting closer. After balancing the blades and replacing my tail shaft, I finally got the vibrations down to an acceptable level. I can't wait to get outside...
[link=http://s93421871.onlinehome.us/bladetailwood.wmv]Blade CP with 200Mw 2.4GHz Black Widow System (KX-141)[/link]
I am using a 850Mah 3S Lipo for the helicopter and camera (using a 5v switched converter). The entire ship with camera setup weighs in at 11oz (up from 9oz for the stock blade with battery, using my rough cooking scale).
Steve
[link=http://s93421871.onlinehome.us/bladetailwood.wmv]Blade CP with 200Mw 2.4GHz Black Widow System (KX-141)[/link]
I am using a 850Mah 3S Lipo for the helicopter and camera (using a 5v switched converter). The entire ship with camera setup weighs in at 11oz (up from 9oz for the stock blade with battery, using my rough cooking scale).
Steve
#4
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Portsmouth, NH,
Posts: 814
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blade CP Video Setup...
Yep, the tail did get a bit too close to both me and the cat that time. These little CP heli's are a handfull in the house.
Steve
Steve
#5
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Portsmouth, NH,
Posts: 814
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blade CP Video Setup...
Here is a shot from the back yard. I am fairly happy with the vibration level. It only gets bad once and a while (some specific RPM's). If it were not for the trees (and me being a chicken) I could have easily gained much more height. The blade has a ton of power with this setup, lift is no problem at all.
[link=http://s93421871.onlinehome.us/bladecp2.wmv]Blade in the yard (tail onboard)[/link]
Steve
[link=http://s93421871.onlinehome.us/bladecp2.wmv]Blade in the yard (tail onboard)[/link]
Steve
#6
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Portsmouth, NH,
Posts: 814
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blade CP Video Setup...
I got out today again (no wind) and got a shot in the street in front of my house. I just can't get higher without chickening out...
Steve
[link=http://s93421871.onlinehome.us/bladecp3.wmv]Blade on Street (high)[/link]
Steve
[link=http://s93421871.onlinehome.us/bladecp3.wmv]Blade on Street (high)[/link]