As a brand spankn' new glider pilot I'm exploring the sailplane side of this transmitter for the very first time and have a question regarding flaps or should I say flaperons since the plane doesn't have typical "flaps".

Set up flaperons on S1 stick switch using crow. One thing I can't figure out is how to mix elevator with the "flaps". Would like to set up a point curve and tried several things but no matter what I try just can't seem to get the elevator to move with the flaperons.

Scott

Never mind. Figured it out. [8D]

Found the missing step in the process.

I'm stuck on the same issue. Care to share how you did it?

For me the missing link was simply turning the function on.

In the SYSTEM menu go to (13) SW ASSIGN. Scroll down to Fl to EL. In the first column change it to say "ON"

If that doesn't work for you shoot me a PM, I don't check this forum very often.